Concept OV5200 Bedienungsanleitung Seite 56

EN
FUNCTIONS AND FEATURES
1. Airflow mode: normal, natural, sleep mode and intelligent mode.
2. Three levels: high, medium and low.
3. Humidification/Cooling.
4. Setting the shut down time: The scheduled shut down time can be increased in 0.5 hour steps, up to 8 hours.
5. Air flow direction: 360° fan blade rotation.
6. Electronic button control, digital time and temperature display.
7. Infrared remote control.
8. Water tank, simple maintenance.
9. High quality water filter with great evaporation and excellent cooling effect.
10. Spray cooling technology, large recycling capacity, faster cooling.
11. Protection against power failure, protection against water shortage in the tank.
12. Double air filtration.
13. Universal front wheel construction.
OPERATION GUIDELINES
The appliance can be used immediately after removal from the box (without installation).
Using the function buttons
Plug the appliance into the socket, a beep sounds, and the system enters the stand-by mode. If you do not press
any button within one minute after turning on any light or display, both the light and the display will darken
(33% brightness). If the button is pressed, the light and the display will light up.
ON/OFF button
• When the appliance is switched on, pressing this button a long beep sounds, the appliance switches off and goes
into stand-by mode.
• If the appliance is switched off and the ON/OFF button is pressed, all the LEDs will flash clockwise. The appliance
then switches to the default operating mode, except the timer, sleep mode, and the natural mode. (Note: The
appliance switches to the default operating mode only if the power cable is disconnected for the first time. If you
turn the appliance off and do not pull the power cord out of the socket, the appliance will switch to the last know
mode, when it is turned back on.) Below are the default operating modes:
- normal start-up mode, without LED display;
- the digital display shows the ambient temperature, the "C" indicator lights up;
- the blade indicator is off;
- cooling/humidification is off;
- start at medium level, switching to low level after three seconds;
- the timer function is off, the indicator turns off.
Speed setting button
If the appliance is switched on, press the speed button and select the low, medium or high level.
Cooling/humidifier button
If the appliance is switched on, press this button to turn on/off the cooling/humidification mode and the
corresponding light on the display lights up.
Timer button
• When the appliance is turned on, the timer is off by default, and the digital display shows the ambient temperature.
When you press the timer button for the first time, the "H" indicator lights up and the timer is set to 0.5 hours. Each
time you press the button, you increase the time by 0.5 hours, up to 8 hours. If you press the button again, 00 will
appear on the display and the timer will turn off. Press the button again to repeat the cycle.
56
OV5200