Installation; General; Countertop Installation - Hatco TMS Series Installations- Und Bedienungshandbuch

INSTALLATION

General

THERM-MAX Salamanders are shipped with most components
pre-assembled. Care should be taken when unpacking the
shipping carton to avoid damage to the unit and the
components enclosed. The salamander can be placed on a
countertop or mounted to a brick or cement wall. The following
installation instructions must be performed before operating the
salamander.
WARNING
ELECTRIC ShOCk hAzARD:
• Unit must be installed by a qualified electrician.
Installation must conform to all local electrical codes.
Installation by unqualified personnel will void unit
warranty and may lead to electric shock or burn, as well
as damage to unit and/or its surroundings.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 21°C (70°F)
and a maximum of 29°C (85°F).
FIRE hAzARD:
• Install unit on and around non-combustible surfaces
with non-combustible construction only. Ensure
surface construction has no combustible material
against underside. In all cases, such construction
shall extend at least 305 mm (12") beyond equipment
on all sides.
• Locate unit a minimum of 51 mm (2") from any walls. If
safe distances are not maintained, discoloration or
combustion could occur.
• Do not obstruct air intake openings or air exhaust
openings on outer housing of unit. Unit combustion or
malfunction may occur.
• Do not place anything on top of unit.
For wall mounting, use special wall mount bracket
provided with unit only. Secure wall mount bracket to a
solid, non-combustible surface using appropriate hardware
for mounting surface and weight of unit.
Locate unit at proper counter height in an area that is
convenient for use. Location should be level to prevent unit
or its contents from falling accidentally and strong enough
to support the weight of the unit and contents.
Do not place anything on top of unit; doing so may subject
personnel to injury or damage unit.
NOTE: A qualified person must check possible placements of
the salamander to ensure that the proper electrical
supply line is available.
1. Remove the unit from the shipping carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online
IMPORTANT OWNER INFORMATION section for details.
2. Remove tape and protective packaging from all surfaces
of unit.
3. Clean the unit thoroughly to remove all protective industrial
grease. NOTICE Use non-abrasive cleaners and cloths
only.
CAUTION
warranty registration.
4. Remove the transport locking screw used to secure the
upper housing during shipping. Discard the screw.

Countertop Installation

1. Place the unit in the desired location.
• locate the unit directly underneath an exhaust hood if
possible. This will ensure total suction of steam
produced during cooking.
• Make sure the unit is at the proper height in an area
convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop with a minimum
of 51 mm (2") between the unit and any wall.
See the
Figure 5. Minimum Distance Requirement
2. level the unit by turning the leveling feet on each leg, if
necessary. When looking at the bottom of the unit, turning
the feet counterclockwise will lengthen the legs, and turning
the feet clockwise will shorten the legs.
3. Have a qualified electrician perform the necessary electrical
connections (refer to "Electrical Connections" in this section
for additional information).
6
Transport Locking
Screw
Figure 4. Transport locking Screw
Countertop
Form No. TMSCEM-0911
51 mm (2")