Principle Of Operation - saniself US-5 BASIS Installation Und Betriebsanleitung

ATTENTION! ENERGY EFFICIENCY!
Please note that the water heater can also be operated in so-called frost protection and power
saving modes.
Please refer to the Section "Operation and Maintenance" for detailed information about this.

PRINCIPLE OF OPERATION

The free outflow water heater can supply hot water to one water withdrawing location.
The hot water obtained is suitable for both cleaning and drinking purposes, provided that the
supplied cold water is of proper quality.
The temperature of the water in the water heater can be set as needed, but up to max. 80°C. Upon reaching
the preset temperature, the heating is automatically turned off by the temperature regulator. The heat
insulation surrounding the inner tank prevents the cooling of the water, thus ensuring the availability of
hot water from the container over a long time. The design of the appliance ensures that hot water is
discharged after minimal mixing with cold water.
The inner tank is made of special polypropylene, which ensures a long service life for the water heater.
INSTALLING THE WATER HEATER
Installation and connection of the water heater must be carried out by a qualified technician in line
with the provisions of IEC 60364.
The water heater is suspended using the 2 pcs 6x45 hex head wood screws, 2 pcs washers and 2 pcs plastic
dowels provided with the appliance.
Insert the wood screws along with the washers into the plastic dowels, so that they protrude app. 5-7 mm
from the wall surface.
Leave a clearance of at least 50 mm in each direction around the appliance.
Place the water heater on the screws, in such way that the washers must be inside the appliance.
15