Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WARNING:THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured
in accordance with the following code:
Green and Yellow:
Blue:
Brown :
DO NOT run microphone cables near mains, data, telephone or 100V line cables.
DO NOT run 100V line cables near data, telephone or other low voltage cables.
DO NOT exceed 90% of the amplifiers output power when using 100V line (speech only).
DO NOT exceed 70% of the amplifiers output power when using 100V line (high level
background music).
DO NOT use re-entrant horn loudspeakers for background music unless the loudspeaker has
been specifically designed for this purpose.
AVOID
jointing the microphone cable, when this is unavoidable make sure a good screened
connector is used, e.g. XLR.
ALWAYS use a balanced or floating low impedance microphone terminating into a balanced
input on long microphone cable runs.
ALWAYS use a mains grade double insulated cable for the loudspeaker cable runs.
ENSURE that all loudspeakers are in-phase.
ENSURE that there are no short circuits on the loudspeaker line before connecting to the
amplifier.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured markings
identifying the terminals in your plug proceed as follows:
•
•
Earth
(E)
Neutral (N)
•
Live
(L)
If a 13 Amp (B.S.1363) plug or any other type of plug is
used,a 5 Amp fuse must be fitted either in the plug or at the
distribution board.
GENERAL INSTALLATION
The green and yellow coloured wire must be
connected to the terminal that is marked by the letter E,
marked by the safety earth symbol or coloured green
and yellow.
The blue coloured wire must be connected to the
terminal that is marked with the letter N or coloured
black.
The brown coloured wire must be connected to the
terminal that is marked with the letter L or coloured red.
Werbung
Inhaltsverzeichnis
