Declaration Of Conformity - V2 ECO-LOGIC Bedienungsanleitung

IMPORTANT INFORMATION
For any installation problem please contact our Customer
Serviceat the number +39-0172.812411 operating Monday to
Fridayfrom 8:30 to 12:30 and from 14:00 to 18:00
V2 reserves the right to make modifications to the product
without any prior warning; furthermore, the company
declines all responsibility for damages to people or
property resulting from improper use or incorrect
installation.
Read the following instruction manual thoroughly
prior to proceeding with installation and programming of
the system.
• This instruction manual is intended solely for use by technical
staff, qualified in the field of installation of automation
devices.
• None of the information contained in the manual is of interest
or use to end users.
• All maintenance or programming operations should be
conducted exclusively by qualified staff.
The installation, testing and commissioning of door and gate
automation devices should be performed by qualified and skilled
personnel, who must assume responsibility for setting up the
tests envisaged depending on the risks present; and verify
compliance in accordance with legal and regulatory requirements.
• V2 accepts no responsibility for injuries and damage resulting
from improper use of the product; other than that described in
this manual.
• Packing materials must be disposed of in full compliance with
local regulations.
• Ensure that the back-up battery cannot become immersed in
water or other liquids. Should any liquids penetrate inside the
device, disconnect it immediately from the automation device
and contact the V2 assistance service; use of the device under
such conditions may be hazardous.
• Do not store the back-up battery close to strong sources of
heat or expose it to naked flames; such actions can damage it
and be the cause of malfunctions, fire or other hazards.
• In order to avoid the risk of leakage of hazardous substances
from the back-up battery in the case where the device is not
used for long periods of time, it is preferable to disconnect it
from the automated device and store it in a dry place.

DECLARATION OF CONFORMITY

V2 S.p.A. hereby declares that the product ECO-LOGIC complies
with the essential requirements established in the following
directives:
89/336/EEC Electromagnetic compatibility directive (EMC)
Racconigi, 02/11/2009
V2 S.p.A. legal representative
Cosimo De Falco
PRELIMINARY CHECKS AND
LIMITS OF USE
Perform the checks described in this chapter to ensure that the
product is suited to the characteristics of the automation device
to be supplied.
Nearby the automation device to be supplied, identify the most
suitable point for installing the solar panel and the most suitable
point for installing the accumulator unit, taking the following
points into consideration.
Solar panel
• The maximum length of the solar panel cable should not
exceed 10 m.
Use a 2x1 mm 2 cable (maximum outer diameter 6.5 mm)
• The surface selected for fixing both devices should be of solid
material and should guarantee stable fixing
• The location selected for installation of the panel should
guarantee 100% direct sunlight throughout the year
• The location selected for installation of the panel should be
away from plants, walls or anything else that might cast
shadows, even partial, over the sensitive surface.
Partial shadows significantly reduce the energy capacity of the
panel.
Accumulator
• The maximum length of the cable carrying power to the
control unit should not exceed 3 m.
Use a 2x1,5 mm 2 cable (maximum outer diameter 10 mm)
• The device should be installed in a location protected from
direct sunlight and possibly also at low temperature.
Such extreme conditions compromise battery yield and
lifespan.
• Never allow the battery to discharge to the point where the
red LED remains on, since this risks irreparable damage to the
battery.
7