Installation - V2 ECO-LOGIC Bedienungsanleitung

INSTALLATION

CAUTION: do not connect the grey terminal until
installation of the panel is complete.
1. Fix the bracket to the wall using appropriate rawplugs
2. Position the accumulator unit on the bracket and tighten the
V-screws on the base
3. Fix the solar panel using the adjustable brackets
4. Position the panel (see the section on POSITIONING
THE PANEL)
5. Connect the panel to the grey connector fixed to the
accumulator unit:
• Loosen screw A and extract the connector
• Remove gasket B and open the connector, by using a
screwdriver as a lever in slot C.
• Connect the + terminal of the panel to the terminal 2 of
the accumulator connector
• Connect the - terminal of the panel to the terminal 1 of
the accumulator connector
• Replace gasket B, insert the connector and tighten screw A
PLEASE NOTE: Do not remove the pre-wired jumper inside
the connector
6. Connect the control unit power supply to the black connector:
positive to terminal 3 and negative to the earth terminal
7. Insert the black connector first followed by the grey connector.
Check that all LEDs come on a for a few seconds and then the
green LED continues to flash; if the panel is lit by sunlight then
the yellow LED should also flash.
Solar panel Accumulator unit
9