Werbung
INSTRUKTIONER
To prepare the Lacronite Pool Pump for direct replacement of a Hayward Supa Pump the large
support base of the Lacronite Pool Pump will need to be removed and replaced with the provided
support foot as identified previously.
1. Remove Bolts & Nuts from Point "A" & "B" on both left & right sides of the Lacronite Pump. This
will remove the large support base.
Note: This support Base is no longer required with this Pool Pump installation.
2. Fit the provided support foot to the bottom of the Lacronite Pool Pump, and ensure the front
locating lugs are properly inserted to the retaining slots under the pump wet end and the back
retaining lugs align with Point "A" on the Lacronite Pool Pump.
3. Using Point "A" Bolt & Nuts tighten & secure the rear support foot lugs to the Lacronite Pool
Pump.
Note: Point "B" Bolts & Nuts are no longer required with this installation.
Your new Lacronite Pool Pump is now ready for easy installation to the pools existing Hayward
Supa Pump plumbing.
Point A
Point B
LACRONITE POOLPUMP
Werbung
