Ghibli M7 Gebrauch Und Wartung Seite 15

Professional hose assembly for fabric
washing (if present)
After connecting the suction hose to the out-
let the drum, do as follows:
- Insert the fabric nozzle (16 Fig.9) into the
flexible hose (17 Fig.9).
- Connect the detergent hose (18 Fig.9)
to the quick coupling (19 Fig.9) on the
flexible hose; to release it push the quick
coupling (19 Fig.9) towards the hose.
Filling the detergent tank
- Remove the cap (20 Fig.10) and pour the
detergent liquid (suitable for the surfaces
to be washed) into the tank (21 Fig.10) .
NOTE:
For detergent dosing refer to the manufac-
turer's instructions.
- Put the cap back on (20 Fig.10)
USING THE APPLICANCE
- The appliance is fitted with wheels and
can therefore be pulled along using the
flexible hose.
- To lift it up, insert your fingers under the
handle (22 Fig. 11) on the top of the cov-
er.
Starting up the appliance
- Insert the plug (23 Fig.12) into the electri-
cal socket.
- Push the switch (24 Fig.13) on "I" to start
the suction motor; the switch lights up.
- Push the switch (25 Fig.13) on "I" to start
the detergent pump; the switch lights up.
NOTE:
The suction motor and the detergent pump
operate independently; therefore, it is pos-
sible to:
- wash fabrics or floors/ carpets by starting
only the detergent pump;
- wash and suction liquid simultaneously
by starting up the detergent pump and
suction motor at the same time;
- suction liquids by only starting the suction
motor.
NOTE:
For the ergonomic handle (if present) it is
possible to adjust the suction force using the
selector (26 Fig.14).
The suction force is decreased by opening
the window (27 Fig.14).
Washing floors or carpets
- To wash floors or carpets it is necessary
to mount the hose with ergonomic handle
(9 Fig.15), the rigid extensions (10 and 11
Fig.15) and the floor nozzle (13 Fig.15), if
present.
- Start the suction motor and the detergent
pump by pressing the relative switches
(24 - 25 Fig.13).
- Press the switch (28 Fig.15) to dispense
the detergent, release the button to stop
dispensing.
The switch (28 Fig.15) can be blocked in
the pushed position (continuous deter-
gent dispensing) by moving the slide (29
Fig.15) towards the switch (28 Fig.15).
When the slide (29 Fig.15) is moved back
to its original position the switch is re-
leased and detergent dispensing stops.
- The detergent released washes the floor/
carpet / and the dirty liquid is suctioned
into the tank of the appliance.
For very dirty areas it is recommended
you apply detergent to the dirty area with-
out suctioning it; leave the detergent al-
lowing it to work for several seconds and
then wash the area and suction the dirt.
EN - 7
EN