Dimensions For Scale Installation - Sartorius YEG01 08 Series Installationsanleitung

Dimensions for Scale Installation

Model Scale outer
dimensions
mm
800 + 800
MAP_-II
MAP_-LI 1000 + 800
1000 + 1000
MAP_-LL
MAP_-NL 1250 + 1000
1250 + 1250
MAP_-NN
MAP_-RN 1500 + 1250
1500 + 1500
MAP_-RR
MAP_-WR 2000 + 1500
D
E
All dimensions given in millimeters
Notes:
– Use a spirit level when adjusting the pit frame edges.
There must not be any gaps between pit frame edges and the inner wall of the pit.
– The supports in the corners of the foundation are the points upon which the scale rests. Make sure these supports are level.
– Check the accuracy of dimensions and angles and adjust as needed.
– The general usage and any traffic within the area, as well as the existing construction at the place of installation, must be taken into
account when determining the required strength of the foundation.
– No slope is required when the weighing platform is installed in a dry area.
– As long as it does not go through one of the four supports, the protective conduit can be installed at any position on any side of the
foundation.
– The upper edge of the conduit must be lower than the load plate of the weighing platform.
Pit dimensions
A B
mm mm
815 815
1015 815
1015 1015
1265 1015
1265 1265
1515 1265
1515 1515
2015 1515
C
50
50
F
C D
mm mm
250 102
250 102
250 102
250 102
250 102
250 102
250 102
250 102
A
10; 80 mm deep
Bore holes for
anchors
E F
mm mm
150 32.5
150 32.5
150 32.5
150 32.5
150 32.5
150 32.5
150 32.5
150 32.5
G
mm
117.5
117.5
117.5
117.5
117.5
117.5
117.5
117.5
5