Helps & Hints - Ellison Prestige Pro Bedienungsanleitung

With some XL, XL-L or DC dies, it is helpful to cut an extra time in the

middle of the die.
Use Prestige Pro to cut a variety of different materials. See Materials Guide

on pages 13 and 14 for suggestions.
Fewer sheets of material may be required when cutting very intricate shapes.

Use only one sheet of material with SureCut Crease Rule Dies.

When cutting thin fabrics, place a scrap of paper over the material.

When cutting with a die that is asymmetrical (uneven distribution of the cutting

rule on dies, such as Uppercase "T" or Sailboat), move the die approximately
1/4" farther into the machine so that the end with the greater amount of rule is
closer to the center of the machine (under the Pressure Bearings).
A convenient way to store the dies is on their sides. Place the Die Storage

Rack on its side so the dies sit vertically in the rack, not horizontally. Insert
the dies alphabetically in the rack from left to right, so they are easier to find
and replace. The dies will also slide into the slot with greater ease and are
less likely to catch on the shelf divider. (Not applicable to the Wall Storage
Rack, the Work Station Rack or Carousel.)
It is important to use the Die Pick (included in the Tool Kit) to clean out the

bits of paper and other material that build up in the joints of the dies (where
the cutting or creasing rule meets). If dies are not kept clean, the scraps will
eventually push the rule slightly apart. This cleaning is especially important if
cutting thick materials such as Flexible Magnetic Sheets, Pop-Up Sponge or
Self-Adhesive Felt.
Helps & Hints
8