Using Surecut Crease Rule Dies; Suggestions For Successful Cutting - Ellison Prestige Pro Bedienungsanleitung

Pressure
Plate
Die
Material
Cutting Pad
Back

Using SureCut Crease Rule Dies

A SureCut Crease Rule Die is similar to a regular SureCut Die; however, it

contains both cutting (sharp) rule and crease (blunt) rule.
Crease rule dies require the Premium Cutting Pad.

Use only one sheet of material at a time to prevent the crease (blunt) rule

from cutting through the paper.
Refer to Operating Instructions (page 5).

If crease rule is cutting through the material rather than creasing the

material, remove Mylar Shims one at a time (Figure I, page 9) until desired
creasing occurs.

Suggestions for Successful Cutting

With some XL or DC dies, and with any oversized dies (XL-L), it is helpful to cut
an extra time in the middle of the die.
Prestige Pro can be used to cut anything scissors can cut. See Materials Guide
on pages 13 and 14 for suggestions.
Turn the Cutting Pad over routinely (weekly for high usage), turning from side to
side. Turning the Cutting Pad allows both sides to wear evenly. Replace Cutting
Pad when both sides are worn and no longer cutting with one pull of the handle.
Note: If a Cutting Pad is not turned routinely and is severely worn on one side,
it may cause a slight warping of the pad, thereby making it impossible to use
the reverse side. Properly discard the Cutting Pad and replace with a new one
(see Replacing the Cutting Pad, page 10). NEVER place any material on top of
dies. Some Ellison dies come with a Quick Cut Shim pre-attached with
instructions. No other dies require a Quick Cut Shim.
Figure F
Front
7
Right Side
Left Side
Figure G