Using Extra Large, Extra Large-Long And - Ellison Prestige Pro Bedienungsanleitung

Pressure
Plate
Die
Material
Cutting Pad
Figure D
Using Extra Large (XL), Extra Large-Long (XL-L) or Double Cut
™
(DC) SureCut and ClearCrop
An Extra Large (XL) or Double Cut (DC) Die is twice as long as a Tiny, Small or
Large Die and requires two cuts.
1. Raise the handle all the way up.
2. Place the material to be cut against the rubber side of the die and place
rubber side down on the Cutting Pad.
3. For XL and DC dies, slide the Cutting Pad to position the material and die
so that the edge of the die is flush with the back of the Pressure Plate
(Figure C for XL dies and Figure F for DC dies). Vary the die placement for
Double Cut (DC) dies from side to side to prolong the life of the Cutting Pad
(Figure G, page 7).
4. Lower the handle one time to cut through the material.
5. Raise the handle to slide the Cutting Pad through the machine so the
exposed end of the die is now flush with the front end of the Pressure Plate
and cut again (Figure D for XL dies and Figure G for DC dies).
6. With some intricate shapes or XL-L dies, it may be necessary to cut a third
time in the middle of the die. Center die in machine and lower the handle to
cut again (Figure E).
7. Keep a firm grip when raising or lowering the handle.
8. Slide the Cutting Pad out from under the Pressure Plate and remove the die
and perfectly cut shapes, letters and numbers.
Back
Figure C
Figure E
™
Dies
6
Front