Operating Instructions; Using Standard Surecut And Clearcrop Dies - Ellison Prestige Pro Bedienungsanleitung

Operating Instructions

Pressure
Plate
Die
Material
Cutting Pad
Back
Figure A
Using Standard SureCut
1. Raise the handle all the way up.
2. Place material to be cut against the rubber side of the die and place rubber
side down on the Cutting Pad.
3. Slide the Cutting Pad to center the material and die under the Pressure
Plate (Figure A).
Note: Vary die placement from side to side to prolong the life of the
Cutting Pad (Figure B).
4. Lower the handle one time to cut through the material.
5. Keep a firm grip when raising or lowering the handle.
6. Slide the Cutting Pad out from under the Pressure Plate and remove the die
and perfectly cut shapes, letters and numbers.
Front
and ClearCrop
™
5
Right Side
Left Side
Figure B
Dies (Large, Small and Tiny)
™