Toshiba RH-251218EEU Bedienungsanleitung Seite 14

OPERATION INSTRUCTION
[Inspection before start]
1. The power cord shall not be damaged or fractured.
2. Please verify the rated current of the power socket is in line with the requirements in
the table above and is equipped with a safety grounding device before use; otherwise,
replace the socket.
[Operating Instructions]
<Work/Standby>:Plug in the power, the buzzer will "beep" for along time, press the
standby key " " to enter the high-grade heating working state, and then press the
standby key " " to enter the standby state.
<Gear selection>: For work status, press "MODE" key to select one of work modes
such as high gear, medium gear, low gear and energy saving gear.
<Temperature Setting>: Under the working status, press and hold the "
" " key to set the temperature, press and hold the "
set the temperature; after setting the temperature, have non-operation for 5 seconds,
exit the temperature setting screen. After the initialuse or memory clear, the whole ma-
chine runs according to the factory settings. The default setting temperature is 35° C
and the gear position is high-end.
<Scheduled work>: Tap the timer key "
work setting screen. Press "
" key or " " key for along time to quickly set the scheduled time, and the scheduled
time will reach the working status of the machine. The buzzer will ring with along beep.
<Scheduling standby>: Under the working status, press the timer key "
scheduling standby setting screen. Press "
time, press " " key or "
the scheduling time is in the standby state to the machine.
A: the scope of scheduling is for 0~24hours, and press "
increase or decrease 1 hour. When the set value is 0H, press the "
time for 24H.When the set value is 24H,press the "
When the set value is 0H, the scheduling is canceled. When the set value is not 0H,
the scheduling is started. Set the appointment time, press the timing key "
"MODE" key, or without operation for 5 seconds, exit scheduling mode.
" in standby mode to enter the scheduled
" key or " " key to set the scheduled time, press "
" key or "
" key for along time to quickly set the scheduling time, and
11
: Temperature decrease
: Standby key
: Temperature increase
: Timer key
: Mode key
" key or
" key or the " " key to quickly
" to enter the
" key to set the scheduling
" key or " " key each time to
" key to set the
" key, and the setting time is 0H.
" key or