Placement Of The Base; Use; Using The Product - Powerfix Profi HG09204 Bedienungs- Und Sicherheitshinweise

Push the fixing clamp
set the desired height. Tighten the fastening screw
turning it clockwise.
Placement of the base (Figure D)
The soldering iron holder
right or left side on base
as an option for left or right-handed user.
The soldering iron holder
correct position to rear side of the base
Figure D in order to prevent restriction on use of the preci-
sion engineer's LED magnifying glass
and alligator clips

Use

Using the product

Turn the retaining screws
a clockwise direction. Clamp the item to be repaired with
the alligator clips
Move the On / Off switch
on the LEDs
Note: The LED bulbs
Point the precision engineer's LED magnifying glass
with the LED lamps
28 GB/IE
on to the mounting rod
7
13
14
13
.
18
19
in the repair device
18
9
.
20
are non-replaceable.
20
at the clamped work piece.
20
could be installed on either
with screwdriver (not included)
should be adjusted the
14
, fixing clamp
1
on the alligator clips
15
into position "ON" to switch
and
10
by
8
as shown in
11
in
18
.
1