Connection of an aerial
Insertion of the batteries into the remote control
Using the remote control
Connecting the mains cable
10
30° 30°
S
If you would like to connect cable or a terrestrial
aerial, use the "AERIAL" socket provided for this
purpose.
S
Open the cover of the battery component.
S
Insert the two batteries (AAA) supplied into the
battery compartment.
Pay attention to the polarity (+) and (-) marked on
the bottom of the battery compartment.
S
Close the cover of the battery compartment.
Use the remote control within a distance of about 6 m
from the remote control sensor on the plasma TV and
within a horizontal and vertical angle of 30°.
The remote control may not work, if the remote control
sensor of the plasma TV is exposed to direct sunlight
or strong artificial light.
S
Insert the mains cable into the mains input socket
on the plasma TV and the mains plug into a
mains outlet.
S
Switch the mains switch on the rear side of the
plasma TV to position "I". The plasma TV is now
in standby mode and can be switched on with the
remote control.
ENGLISH