Preparations; Viewing Direction; Location; Installation - Cinemateq VQF 42HD Benutzerhandbuch

Preparations

Preparations

Viewing direction

D Despite the large viewing angle the plasma TV offers the
best performance with a directly vertical viewing direc-
tion. Align the plasma TV with the most frequently used
viewing direction.

Location

D Light reflection
Avoid locating the unit opposite windows or other light
sources.
D Access to the mains input
The mains input and mains switch should be easily
accessible at all times.
D Air supply
To ensure sufficient ventilation, the supply air and
exhaust air openings of the plasma TV must be kept
absolutely free.
If installed in an alcove, keep the minimum distances
large enough to allow sufficient ventilation of the plasma
TV.
A = 10 cm; B = 20 cm
Ensure the following minimum spacings for wall moun-
ting:
A =20 cm; B = 30 cm.
8
D Ambient temperature
For safe and reliable operation the ambient temperature
must be between 5 °C and 35 °C.

Installation

D Two persons are required to remove the plasma TV from
its packing. Never lift the plasma TV alone. An attempt to
lift the plasma TV alone will put your health at risk.
D Place the plasma TV on a stable and horizontal base.
The subsurface must be firm and capable of bearing a
static load.
D Before installation make sure that the plasma TV is
switched off and that the mains cable and signal cable
are unplugged.

Wall mounting

D The plasma TV must be mounted on vertical walls only.
D Before mounting the set, check whether the loadbearing
capacity of the wall is suitable for 3-times the weight of
the plasma TV (for the weight see page 31 "Technical
specifications"). If in doubt, seek the advice of a qualified
installer.
D Before installation make sure that the plasma TV is
switched off and that the mains cable and signal cable
are unplugged.
D Two people are required for the mounting work.
D Turn the plasma TV so that the front side (screen) is
pointing downwards and place it carefully on a com-
pletely flat and firm surface.
D Loosen the 4 screws (M4x12) in the table feet and
remove them.
Screws M4x12
ENGLISH