Adjusting The Laser Line - GMC SYT210 Bedienungsanleitung

5. Using a Phillips head screwdriver loosen and
remove the Phillips head screw that secures
the Blade Bolt Cover (Fig. g)
6. Pull the Rotating Blade Guard (4) down, then
swing it up together with the Blade Bolt Cover
(15). When the Rotating Blade Guard (4) is
positioned over the upper Fixed Blade Guard
(3) it is possible to access the blade bolt (fig.
h)
7. Hold the Rotating Blade Guard (4) up and
press the Spindle Lock Button (28) (Fig. i).
Rotate the blade until the spindle locks
8. Use the 6mm hex key provided to loosen and
remove the blade bolt. (Loosen in a clockwise
direction as the blade screw has a left hand
thread) (Fig. j)
9. Remove the flat washer, outer blade washer
and the blade
10. Wipe a drop of oil onto the inner blade washer
and the outer blade washer where they
contact the blade
11. Fit the new blade onto the spindle, taking
care that the inner blade washer sits behind
the blade. IMPORTANT: Ensure the direction
of the arrow printed on the side of the blade
matches the direction of the arrow on the side
of the upper blade guard
12. Replace the Outer Blade Washer (Fig. k)
13. Depress the Spindle Lock Button (28) and
replace the flat washer and blade bolt
14. Use the hex key to tighten the blade bolt
securely (tighten in an anti-clockwise direction)
15. Lower the blade guard, hold the Rotating
Blade Guard (4) and Blade Bolt Cover (15) in
position and tighten the fixing screw
(Fig. l)
16. Replace the guard retraction arm and secure
onto the rotating blade guard
17. Check that the blade guard operates correctly
and covers the blade as the saw arm is
lowered
18. Connect the saw to the power supply and run the blade to make
certain that it is operating correctly

Adjusting the laser line

g
• The laser is factory set to emit a laser line aligned with the centre
of the blade
• If it moves out of alignment, it is possible to correct this
To adjust the position of the laser:
1. Check that the blade is square with the table and zeroed on the
bevel scale (see 'Setting the table square with the blade' above)
h
2. Remove the laser cover by pulling it towards you
3. Switch on the laser light with the Laser Light On/Off Switch (16)
4. Using a Phillips head screwdriver (not supplied), adjust the
position of the line by turning the Laser Pitch Control (5)
5. Adjust until the laser line is aligned with the centre of the blade
6. Switch off the laser light and refit the laser cover
Brushes
i
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent
failure, or visible sparking
• If you suspect that the brushes may be worn, have them replaced
at an authorised service centre
j
Disposal
Always adhere to national regulations when disposing of power tools
that are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and
electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the
k
proper way to dispose of power tools
l
13
GB