Chapter 7: Using The Equipment; Safety Systems; Residual Risk - Zhermack SAB 1000 Handbuch

WARNINGS
7.1
The equipment must not be used with any of its parts disassembled: before using the
equipment make sure that all its components are properly in place.
To ensure that work is done in absolute safety always make sure that you follow the
described procedures with caution.
To provide greater clarity the numbers given in the diagrams in the following
paragraphs correspond exactly to the numbering in Chapter 3 in the "Equipment
Description" section.

SAFETY SYSTEMS

7.2
In compliance with EC 89/392 international accident prevention standards, these equipments are
fitted with safety devices such as fixed and mobile guards to shield moving parts. This ensures
operator safety when the equipments are in use.
USING THE SAB 1000
7.3
2
3
Figure

RESIDUAL RISK

7.4
Residual risk is:
• a danger that cannot be completely eliminated through design and application of safety devices;
• a potential danger which cannot be highlighted;
• work carried out on the equipment interior by unauthorised personnel.
To prevent accidents always observe the instructions in this manual. Should you have
any doubts at all please contact the manufacturer Zhermack or your Authorised
Servicing Centre.
98 of 136

CHAPTER 7: USING THE EQUIPMENT

Fig. 3: After positioning the aspirator on the floor
correctly (see Chap.6), switch on the equipment by
pressing the main switch (2).
Aspirator operation is interlocked with sandblaster
operation: the aspirator starts working when the
sandblaster is switched on.
MAINTENANCE AND USE MANUAL
EN
SAB 1000