Sony BKM-250TG Bedienungsanleitung Seite 7

Overview
The BKM-250TG 3G/HD/SD-SDI Input
Adaptor is a video signal input adaptor for
Sony professional monitors.
When installed in an input option slot on the
main unit, it provides video input and output
connectors for the main unit and a decoder for
3G/HD/SD serial digital component signals.
Note
There are some monitors that are not
compatible with this unit.
To check if the monitor is compatible with this
unit, refer to the operating instructions for the
monitor.
Function
Decoder for serial digital component
signals
The BKM-250TG supports 3G-SDI that
transmits 1080/50P or 1080/60P signals using
a single BNC cable, and is equipped with a
built-in decoder for 3G/HD/SD serial digital
component signal.
Serial digital input and output signal
connector
The BKM-250TG is equipped with two input
connectors and monitor output connectors that
correspond to each input signal for serial
digital signals.
Time code display
The BKM-250TG can decode the time code
that is superimposed on the serial digital
signals, and display those time code over the
video signals.
Audio level meter display
The BKM-250TG can display the audio level
of the embedded audio over the video signals.
Using the Input and
Output Connectors
For information about installing the BKM-250TG
in an input option slot on the main unit, refer to
the operating instructions for the monitor.
Configuration of input/output
connectors and signals that may be
input
The configuration of the input and output
connectors, and the signals that may be input
are shown below.
Input of serial digital component
signals
You can input serial digital signals to
connectors 1 and output signals displayed on
the screen of the main unit or the monitor from
connector 2.
You need not attach the 75Ω termination to
connector 2.
• The OUT connector (monitor out) outputs
• The signal from the OUT connector does not
Overview / Function / Using the Input and Output Connectors
1
1
3G SDI
IN OUT
1 Input serial digital component signals.
2 Output serial digital component monitor
signals.
Notes
signal only when the power of the main unit
is ON. The monitor out signal is not output
when the monitor is in standby mode.
comply with ON-LINE output signal
specifications.
2
2
250TG
IN OUT
7
GB