ROWENTA DW 8011 PRO Bedienungsanleitung Seite 14

1103904907-index01 DW8000D1:1103904907 index01
PROBLEMS?
Problems
The iron is
plugged in, but
the soleplate of
the iron remains
cold.
None or too
little steam is
being emitted.
Brown streaks
come through
the holes inthe
soleplate and
stain the linen.
Iron is leaking.
If you have any product problems or queries please contact our
Customer Relations Team first for expert help and advice:
0845 602 1454 - UK
(01) 677 4003 - Ireland
or consult our wesbite - www.rowenta.co.uk
* depending on model
Cause
No mains supply.
Temperature control set
too low.
The automatic
electronic cut-out* is
active.
Steam control set on
dry position .
Not enough water in
the water tank.
Anti-Drip* is active
(§ 11).
Residues in the steam
chamber or on the
soleplate.
Use of chemical
descaling agents.
Fabric fibres have
accumulated in the
holes of the soleplate
and are burning.
Your linen is not rinsed
sufficiently or you have
ironed a new garment
before washing it.
Use of starch.
Pure distilled /
demineralised or
softened water is
being used.
Overuse of shot of
steam button.
Soleplate temperature
too low .
12
11/02/09
Solution
Check that the mains plug is
properly inserted or try plugging
the iron into a different socket.
Set the temperature control to a
higher temperature.
Move your iron.
Turn the steam control to the
required setting area.
Fill the water tank.
Wait for the soleplate to reach
the correct temperature.
Use the Self Clean function then
clean your iron.
Do not add any descaling agents
to the water in the water tank.
Use the Self Clean function and
clean your iron.
Clean the soleplate with a
non-metallic sponge.
Vacuum the holes of the
soleplate from time to time.
Ensure linen is rinsed thoroughly
to remove any soap deposits or
chemicals on new garments
which may be sucked by the
iron.
Always spray starch onto the
reverse side of the fabric to be
ironed and clean your iron
soleplate.
Only use untreated tap water or
mix half tap water with half
distilled/demineralised water.
Use the Self Clean function and
clean your iron.
Allow more time between each
shot.
Set the temperature control to a
higher temperature.
Subject to modifications !
15:51 Page 1