Whispbar K559W Fitting Kit Montageanleitung Seite 11

EN
Fitting Kit
K559W
FRONT MOUNTING POINTS ONLY:
Place crossbar foot over grubscrews.
Proceed to: All Configurations
Configuration C:
Use the following grubscrew lengths for
Configuration C:
Centre = M6 x 40mm (1 5/8")
Rear = M6 x 60mm (2 3/8")
Screw grubscrew into adaptor using hex
key. Tighten firmly.
Repeat for all four positions.
CENTRE MOUNTING POINTS ONLY:
Fit rubber pad (supplied with crossbar) to
foot.
Make sure the pad fits into the holes
underneath the foot.
11