Please read and comply with these instructions prior
to the mounting of your appliance. Retain these
mounting instructions for future reference or for subsequent pos-
sessors.
Description
These operating instructions describe the installation of the differ-
ent holders to the S65 oscillating plate head for the following ap-
pliances:
B 60 W
B 80 W
B 60
B 80
B 90 R
The operation of the S65 is described in the operating instruc-
tions of the appliance.
Due to the use of the oscillating plate head S 65, the sound power
level increases to 86 dB (A).
Safety instructions
Assembly must be carried out by a qualified specialist.
–
Turn off appliance and secure against restart.
–
Preparation
Disconnect the water connection and the electrical connec-
tion from the existing cleaning head.
Remove the existing cleaning head.
Assembly
B60 / B 80
1 Support
2 Spacer
3 Screw M6x30
4 Disc 6
Install spacers on the S65.
1 Support
2 Spacer
3 Disc 6
4 Screw M6x30
Screw the holder to the top of the S65, do not tighten yet.
Place the spacer in the front side and screw it in.
Tighten both the screws.
Repeat the upgrade on the opposite side.
Remove the covering plate.
NOTICE
With the B 60 the cable harness on the machine side is attached
to the head suspension by means of a cable tie. Thus, the con-
necting cable is not long enough. Cut this cable tie and pull out
the cable for installation.
1
-
EN
7