1 Support
2 Disc 6
3 Spacer
4 Screw M6x30
NOTICE
With the B 90 R, the holder is mounted to the front of the S65, as
the oscillating head is towed with this appliance.
Screw the holder to the top of the S65, do not tighten yet.
Place the spacer in the front side and screw it in.
Tighten both the screws.
The installed holder at the front of the S65 oscillating head
Remove the covering plate.
10
B 90 R
Establish the electrical connection.
Place the cover plate onto the service opening and screw it in.
Slide the S65 under the appliance.
Create the water connection.
1 Drawbar
2 Rubber grommet
3 Cylinder pin
4 Support
4
-
EN