Balancing The Arm; Optionals; Electrical Connections; Use And Maintenance 3.1 General Safety - Aprimatic PARK 30 PLUS Installations-, Gebrauchs- Und Wartungsanleitungen

2.6 BALANCING THE ARM

ND.3
For balancing the bar see

2.7 OPTIONALS

3.1 GENERAL SAFETY
• The barrier is designed exclusively for vehicles traffi c; report and delimit any walkways through a special sign.
• Keep adults, children and property out of range of the automated system, especially while it is operating.
• For safety reasons and to comply with current standards, we recommend using the control unit.
• To install follow the instructions given in the enclosed "GENERAL INSTRUCTIONS FOR SAFETY" sheet.
• All electrical connections must be done in compliance with current laws.
• The installer must instruct the user on how to use the automatism correctly, on the manual emergency manoeuvre and on the possible risks during operation.
• Analyse the risks and take all the appropriate measures to eliminate them, as prescribed by the EEC machine directive 2006/42, installing the safety devices.
• Always disconnect the electricity before attempting any work on the system with a lockable cut-off switch.

3.2 WARNINGS

Correct controller operation is only ensured when the data contained in the present manual are observed. The Company is not to be held responsible
for any damage resulting from failure to observe the installation standards and the instructions contained in the present manual.
The descriptions and illustrations contained in the present manual are not binding. The Company reserves the right to make any alterations
deemed appropriate for the technical, manufacturing and commercial improvement of the product, while leaving the essential product features
unchanged, at any time and without undertaking to update the present publication.

3.3 USE

• It is essential to follow the instructions given in the enclosed "GENERAL INSTRUCTIONS FOR SAFETY" sheet.
• In the case of a manual emergency manoeuvre, follow the indications described in point 2.5.
• Consult the control unit's installation and operating manual.
3.4 ROUTINE MAINTENANCE (EVERY 6 MONTHS)
• Maintenance must be carried out by qualifi ed personnel only.
• Check the condition of the barrier structure.
• Check tightness of the arm.
• Check the condition of the spring, chain and relative anchorings.
• Check arm balance.
• Check that at the end of travel the arm is horizontal and/or vertical
• Check operation of the manual emergency manoeuvre.
• Check operation of the control unit and safety devices.
2. Installation
pag. 24

2.8 ELECTRICAL CONNECTIONS

ADDITIONAL
LIMIT SWITCH
3. Use and maintenance
TRAFFIC
PARK 230
Consult the control unit's installation
and operating manual
- 11 -
EN
EN