iCES ICR-240 Bedienungsanleitung Seite 5

utto
OFF / NAP
1. For setting alarm time 1 with buzzer, press ALARM / VOL – button (4) and
indicator (E) will flash. For setti g alar ti e with radio, press ALARM /
VOL – utto
4) twice and
2. When the digits are flashing, press HOUR / TUNING –
change the hour setting. Press MIN / TUNING +
the minute setting.
3. Press ALARM / VOL – button (4) to confirm.
4. To cancel alarm, press ALARM 1 / VOL – button (4) three times when the
current time is showing. The alarm indicators will be off.
5. When the alarm sounds, press any button to tur off alar or press SNOOZE /
SLEEP / DIM button (1) to enter snooze mode.
snooze mode. Alarm will sound again after 5 minutes. Alarm buzzer does not cut
the radio sound. If alarm waken up by radio, volume control for radio is not
available.
6. Follow the sa e i stru tio s for alar
Note:
 You must make the time and alarm time adjustments while the display is flashing.
The display will stop flashing after approximately 10 seconds if adjustments are
not made.
 If two alarms are set together, for example alarm1 set to buzzer alarm and alarm2
set to radio alarm, when buzzer is activated by alarm1 and radio is activated by
alarm2, the previous alarm does not stop automatically and has both buzzer and
radio sound together.
RADIO
General Operations
1. Press the ON/OFF/NAP
2. For manual tuning, press HOUR / TUNING –
+ utto
for increments of 0.1mHz.
3. For automatic tuning, press and hold down HOUR / TUNING –
MIN / TUNING +
and the radio will start to scan for the next available station.
4. Press ALARM / VOL –
to tur radio on or off.
indicator (F) will flash.
utto to tur radio o a d off.
utto
for approximately 3 seconds. Depress the button
utto or ALARM / VOL + utto
utto
utto
or
with ALARM / VOL +
utto
or MIN / TUNING
repeatedly to
repeatedly to change
will blink during
utto (8).
utto
or
to adjust