Operation - Klarstein Klagenfurt Handbuch

The rotor display shows which watch winder you have selected.
To start or stop the rotor, press this button. Each rotor can be started and
stopped separately. When the rotor display shows [00], all rotors are started
and stopped simultaneously.
Press the button repeatedly to select the direction of rotation: clockwise only
(CW), counterclockwise only (CCW), clockwise + counterclockwise (CW +
CCW).
Press the TPD button repeatedly to select one of the preset turning programs:
360, 672, 864, 960, 1080, 1200, 1440, 1800 or 2181 TPD (turns per day).
Adjust rotations per day manually: Press and hold the TPD button, then press
and hold the TPD button until [00] is displayed. Then press the arrow buttons
to adjust the TPD value in increments of 16 in the range of 16-9999 TPD
(turns per day). Press and hold the arrow buttons to adjust the value faster.
Press the Light button repeatedly to change the light color as follows: Red >
Green > Blue > Cyan Blue > Yellow > Purple > White.

OPERATION

Note: If you do not use the device for a long time, switch it off. Make sure the unit
is turned off before removing the holder. Do not turn or shake the appliance during
operation.
Starting up
• Connect the mains adapter to the rear of the device and plug the plug into the
socket.
• Open the front cover and carefully pull out the watch holder with your thumb and
index finger.
• Attach the watch to the watch holder and push it back into the unit.
• Close the cover again and press the On/Off button.
Note: When you open the cover, all rotors stop and the display automatically lights
for 30 seconds.
EN
9