Operating The Blender; Using The Control Panel - Hamilton Beach Summit Series Bedienungsanleitung

A-840083400B-ENv01 11/30/01 3:57 PM Page 8

Operating the Blender

Before operating the blender, read the Using the Control Panel and Program Cycles sections on
the following pages to better understand these features. Then, refer to the Using the Blender
section on page 11 for specific operating instructions.

Using the Control Panel

RUN up/down buttons
Press the RUN
blender and run at that speed.
Press and hold the RUN
until the desired speed is reached.
STOP button
Stops operation
of the selected
function.
Does not shut
off power to
the blender.
LCD status messages
8
or button to start the
or button
Cycle buttons A–F
Press any cycle letter A–F to run that cycle.
Press any button to stop the blender.
appears when the container is removed.
appears if the container is on the base and
the unit is ready.
appears if the container is on the base and
the unit has been idle for 1 minute or more.
appears in the event of motor or circuit failure.
Contact Hamilton Beach Commercial service.
To Display Cycle Count:
Press STOP for 10 seconds. Press the PULSE
button to display the cycles. Press STOP to return
to operation mode.
PULSE up/down buttons
Press the PULSE or
the blender. Release to stop.
The display will show the programmed
speed percentage.
To change the speed settings of the
PULSE or button, press and hold
the RUN or button while holding the
desired pulse button.
button to start
LCD display
see below
for status
messages