Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
III - ON / OFF SWITCH ON TRANSMITTER
1. Fully charge 9,6V NiMH battery pack in advance of your use.
2. Turn off the vehicle.
3. Take away the 4 snap pins and remove the vehicle body.
4. Turn the latches on vehicle battery lid to unlock and open.
5. Insert 9,6V battery pack into battery compartment with correct polarity (+/-).
6. Close battery lid, turn the latches to lock properly.
7. Replace vehicle body, insert back the snap pins.
NOTE:
To remove the batteries, reverse the installation procedure.
THIS VEHICLE IS VERY FAST. OPERATE THE VEHICLE CAREFULLY.
TO PROTECT THE RACER'S MOTOR, LET IT COOL FOR AT LEAST 20 MINUTES
AFTER YOU USE A BATTERY PACK.
• Before operating the vehicle, adjust the trim lever first.
STEERING TRIM ST.W
• The "Steering Trim" is to fine-tune the steering. If the front wheels are not straight, adjust the "Steering Trim"
either left / right until the wheels are straight.
TURN VEHICLE AND TRANSMITTER POWER ON.
A
FORWARD
B
BACKWARD
LEFT TURN - FORWARD (at the same time)
C
RIGHT TURN - FORWARD (at the same time)
D
E
LEFT TURN - BACKWARD (at the same time)
F
RIGHT TURN - BACKWARD (at the same time)
After play, always turn vehicle off. Remove batteries from controller and R/C vehicle when not
NOTE:
in use or when storing. Leakage may occur and cause damage if left for a long period of time.
NOTE:
IF THE TRANSMITTER AND THE VEHICLE CANNOT PAIR, PLEASE FOLLOW THE STEPS TO
RE-BIND.
1. Distance.
2. Press and Hold.
3. Turn vehicle power ON.
4. After red light blinks, release.
5. Turn transmitter power ON.
6. Red light on. Binding finished.
IV - VEHICLE BATTERY INSTALLATION
V - HOW TO ADJUST TRIM LEVER
VI - OPERATING R/C VEHICLE
VII - HOW TO RE-BIND
GB
12
Werbung
Inhaltsverzeichnis
