Charge Battery - Briggs & Stratton 80012957WST Aufbauanleitungen

If you need assistance with assembly of the unit, please
contact the web site or phone number shown in the
Customer Contact Guide (if provided) or the Operator's
Manual.
WARNING
Failure to read and follow the safety warnings and
instructions in this document and in the operator's manual
could result in death, serious injury, and/or property damage.
Remove Shipping Crate
WARNING
Protect your eyes and hands when removing shipping crate.
Notice: Steering wheel maybe stored underneath hood for
shipping.

Charge Battery

WARNING
Explosion Hazard - Batteries produce explosive gases.
Corrosive Liquid Hazard - Batteries contain sulfuric acid.
• Always wear safety glasses when working around
batteries.
• Keep all sparks, flames, and cigarettes away from
batteries at all times.
• Never lean over the battery when performing
maintenance.
• Never attempt to charge a frozen battery. Allow it to
warm to 60° F (15.5° C) before charging.
• Always leave vent caps in place to avoid explosions.
Lead Hazard - Battery posts, terminal, and related
accessories contain lead and lead compounds, chemical
known to the state of California to cause cancer and
reproductive harm. Wash hands after handling.
NOTICE:
Never use a battery charger to directly start the engine.
Use only a fully charged battery properly installed.
Never charge the battery with the NEGATIVE (-) cable
attached to the battery terminal.
1
Make sure the ignition is OFF and the key is removed.
2
Charge battery according to the instructions provided by the
charger manufacturer.
3
After charging attach positive (+) cable (red) first.
4
Cover (+) terminal with boot (red).
5
Attach negative (-) cable (black).
1
6
Wash hands after handling.
Install Tires
WARNING
Over-inflating tires may cause them to explode which
could result in serious injury.
DO NOT inflate the tires above the maximum pressure
2
stamped on the sidewall of the tires.
1
Remove loose hardware from carton and organize.
2
Apply grease to spindle.
3
Assemble parts as shown.
4 Apply anti-seize lubricant to axle.
5 Assemble parts as shown.
6
Rotate tire three times to distribute anti-sieze.
7
Assemble parts as shown.
8
Check and adjust the tire pressure. Set the tire pressures to
the values shown on illustration.
Install Seat and Switch
1
Install bolts and tighten securely.
2 Attach harness to seat switch.
3
4
en 7