BOMANN GT 357 Bedienungsanleitung Seite 25

Problem Problem Problem Problem Possible cause Possible cause Possible cause Possible cause
The device is not - Do food items prevent the device lid
working properly
or at all. - Are the ventilation openings clear of
Device cools too Is the temperature control set properly?
much.
The food is too - Is the temperature control set proper-
warm.
- Was the device lid open for an ex-
- Was large quantity of food placed in
- Is the device near a heat source?
Loud noise during Does the device not stand vertical or
operation. horizontal?
Water on the bot- - Is the temperature control set proper-
tom.
- Is the water discharge channel or
The housing sides The refrigeration cycle takes place in the foaming. The heat exchangers are installed
are very warm. in the housing covered. The device cut the interior heat, which must be dissipated
through the housing areas.
Water on the outer On days of high humidity, condensation might occur on the outer surface of the de-
surface. vice. This is no malfunction; you may simply wipe the water off.
NOTE: NOTE: NOTE: NOTE:
If a problem still persists after following the steps above, please contact your trader or an authorized
technician.
from closing properly?
obstruction?
ly?
tended period?
the device within the last 24 hours?
ly?
opening blocked?
Solution Solution Solution Solution
- Arrange the food properly.
- Unblock the ventilation openings, install
the device freely.
Check the temperature setting.
- Check the temperature setting.
- Open the lid only as long as necessary.
- Turn the control panel to a colder setting
temporally.
- Check the installation location (see "In-
stallation").
Adjust the feet accordingly. Liquid flow
sounds in the cooling circuit are normal.
- Check the temperature setting.
- Clean the water discharge channel or
opening.
25