OERTLI AD244 Montage- Und Bedienungsanweisung Seite 6

1 Instructions for assembly and use
1.1 Presentation
The room sensor automatically controls the central control system
depending on the temperature of the room in which it is installed.
The remote control is used to automatically adapt the heating curve
on the circuit concerned.
1.2 Choice of the location
The remote control will be installed against an internal partition, about
1.5 m from the floor in a judiciously choosen "reference" room.
1.3 Attachment
Carefully release the lugs on the front panel from the
ribs in the box using a screwdriver.
Remove the cover.
Drill 2 holes with a Ø of 6 mm. Put the plugs in place. Secure the
box using the 2 screws provided.
6
The remote control is also used to optimise anticipation when the
control panel includes this function
Control panel instructions.
200
8800N036-B
Positions to be avoided
Enclosed, exposed to solar radiation, heated by a flue duct, exposed
to cold or hot air currents from air ducts, close to an open fireplace, a
heat source (television), behind a curtain.
Ø 6mm
3
AD244
EN
2
O N
1
O N
04/03/2015 - 300017411-03