HIKOKI NV 90AB Bedienungsanleitung Seite 8

English
(1) Attaching and detaching nose cap
The nose cap can be attached by simply pressing it into
the push lever.
Press it in until a convex part inside the nose cap enters
into a hole of the push lever. (Fig. 12)
Push Lever
Nose cap (A)
For removal, insert a thin rod such as a screw driver into
the gap on the back of the push lever, and then pull it out.
(Fig. 13)
Nose cap (A)
(2) Safekeeping of nose cap
Put the removed nose cap in a space behind the
magazine for safekeeping. (Fig. 14)
3. Adjusting the nail-driving depth
CAUTION:
When making adjustments, be sure remove your fi nger
from the trigger. When making adjustments, be sure
that the nail outlet is not facing downward and that body
parts or other persons are not in the path of the nail
outlet.
○ Adjusting the adjuster (Fig. 15)
Carry out test driving. If the nails are too deep, turn the
adjuster to the shallow side (
8
Nose
Hole
Protruding Section
(inside)
Fig. 12
Push Lever
Slotted-head Screw Driver
Fig. 13
Nose cap (A)
Magazine
Fig. 14
mark).
If the nail depth is too shallow, turn the adjuster to the
deep side ( mark) (see Fig. 15, 16).
Depth is changed 1 mm with each rotation of the
adjuster.
Deep
Flush Too deep
NOTES:
○ When adjusting the adjuster, it does not rotate more
than 3 mm from the deepest point where a nail goes
down. Do not rotate the adjuster by force beyond that
point.
○ The nail-driving depth can also be adjusted by changing
the air pressure used. Carry this out together with
movement of the adjuster. Using a high air pressure that
does not match the nail-driving resistance will shorten
the life of this nailer.
4. Changing the exhaust direction
The direction of the exhaust vent can be changed within
360° by turning the top cover. (Fig. 17)
Exhaust
Vent
Adjustable range of
exhaust direction
Adjuster
Shallow
Fig. 15
Too shallow
Fig. 16
Top Cover
Fig. 17