Troubleshooting Chart - EMAK HC 246 P Bedienungsanleitung

WARNING: Always stop unit and disconnect spark plug before performing all of the
recommended remedies below except remedies that require operation of the unit.
When you have checked all the possible causes listed and you are still experiencing the
problem, see your Servicing Dealer. If you are experiencing a problem that is not listed in this
chart, see your Servicing Dealer for service.
PROBLEM
Engine will not start or will run
only a few seconds after
starting.
(Make sure Ignition switch is
in start position "I" - HC246P-
HC247P-TG2460P-TG2470P)
Engine starts but will not
accelerate properly or will not
run properly at high speed.
Engine does not reach full
speed and / or emits excessive
smoke
Engine starts, runs
accelerates but will not idle.
The engine starts and runs, but
the blade doesn't move
Warning:
touch the
when the engine is
running.

13. TROUBLESHOOTING CHART

POSSIBLE CAUSE
1. No spark
2. Flooded engine.
Carburetor requires adjustment. Contact
1. Check oil fuel mixture.
2. Air filter dirty.
3. Carburetor requires
adjustment.
Carburetor requires adjustment. Turn idle speed screw "T" (Fig. 24)
and
1. Blade incorrectly fitted
2. Blade damaged
never
blade
3. Clutch damaged
SOLUTION
1. Watch for spark at spark plug tip. If
there is no spark, repeat test with a
new spark plug (CMR7H).
2. Follow procedure page 28 If engine
still fails to start, repeat procedure
with a new spark plug.
a Servicing
carburetor adjustment.
1. Use fresh fuel and the correct 2-cycle
oil mix.
2. Clean per instruction
Maintenance-Air Filter Section.
3. Contact a Servicing Dealer for
carburetor adjustment.
clockwise to increase idle speed.See
Operation-Carburetor Adjustment.
1. Contact an Authorised Service
Centre
2. Contact an Authorised Service
Centre
3. Contact an Authorised Service
Centre
I
GB
F
D
E
NL
P
GR
Dealer for
CZ
SK
RUS
in
PL
37