Pix-Star FotoConnect XD series Benutzerhandbuch Seite 5

2. Installation and Power On
First, plug the AC adapter into the back of the device, then plug the AC adapter to a power
outlet.
To turn on the device, hold the power button located on the back/bottom of the device for 3
seconds. The screen should display a logo.
Wait about 25 seconds for the device to start up.
3. Introduction to the Main User Interface
After you power on the device and wait for approximately 25 seconds your Pix-Star will display
the main menu.
You can navigate the menus using the remote control or the buttons located on the back of the
device.
To stop the slideshow and go back to the main menu press the Back button or the Menu
button twice.
When the main menu is displayed on the screen, select the menu you want by using the UP and
DOWN buttons then press the / OK button.
Note: The Back button on the remote control allows you to go back to the previous menu
(upper level menu)