Inhaltsverzeichnis
Werbung
FCC RF Exposure Information and Statement
This device meets the government's requirements for exposure to radio waves. The guidelines
are based on standards that were developed by independent scientific organizations through
periodic and thorough evaluation of scientific studies. The standards include a substantial
safety margin designed to assure the safety of all persons regardless of age or health. The SAR
limit of USA (FCC) is 1.6 W/kg averaged. Device types: Wireless Digital Display (FCC ID: YHO-
PXT51019 and FCC ID: YHO-PXT51519) have also been tested against this SAR limit. SAR
information
on
http://www.fcc.gov/oet/ea/fccid/. Please use the device FCC ID number for search. This
device was tested simulation typical 0mm to body. To maintain compliance with FCC RF
exposure requirements, the use of belt clips, holsters and similar accessories should not
contain metallic components in its assembly; the use of accessories that do not satisfy these
requirements may not comply with FCC RF exposure requirements, and should be avoided.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. - Increase the separation between the equipment
and receiver. -Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED
BY
UNAUTHORIZED
MODIFICATIONS
EQUIPMENT.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
this
and
other
MODIFICATIONS
COULD
VOID
THE
pad
can
be
TO
THIS
USER'S
AUTHORITY
viewed
on‐line
EQUIPMENT.
TO
OPERATE
at
SUCH
THE
Werbung
Inhaltsverzeichnis
