Clearaudio Smart Matrix Professional Bedienungsanleitung Seite 9

TIP: For very dirty records, we recommend allowing the platter to turn more than twice
in each direction and repeating with a second or even third cleaning and vacuum
process.
Please note:
Select anti-clockwise rotation of the platter for vacumming and thereafter do
not switch the rotation during the vacuuming process.
6. Press the 'VACUUM' button to start the vacuum process and wait until the record
surface is completely dry. Press the VACUUM button again to stop the vacuum
process at which point the vacuum arm will lift automatically. Please don't lift up the
vacuum arm before this otherwise a line of fluid may be left on the record.
7. Switch the machine off using the POWER button.
8. Remove the record clamp. Flip over the record and repeat the cleaning process for
the other side.
3.5 Cleaning fluid tank
Please empty the waste fluid tank after 30 – 40 cleaning procedures.
For cleaning the waste fluid tank, remove the upper cleaning arm and fill in the
cleaning fluid into the stainless steel tube. A mixture of 0.5 liter water and two
spoons of vinegar cleaner work well
Pic.8: Emptying the fluid tank
IMPORTANT
Please remember that the fluid release tube must be securely sealed with the
stopper when using the machine.
If not malfunction may occur or even damage the machine!
Page / Seite 8
Smart Matrix
To empty the tank: first remove the stopper
from the fluid release tube (on the rear panel
Smart Matrix Professional
of the
Place the tube in an appropriate vessel to
capture the fluid as it is flows out. Be sure to
securely replace the stopper in the fluid
release tube.
Professional
User manual / Bedienungsanleitung
).
 clearaudio electronic GmbH 2013
l