Clearaudio Smart Matrix Professional Bedienungsanleitung Seite 8

3.4
For simple and effective record cleaning please follow these steps:
Smart Matrix Professional
1. Connect the
main switch on the rear panel on.
2. Take off the vacuum arm from the arm base. Unscrew and remove the record clamp.
Place the Record on the platter and hand-tighten the record clamp onto the spindle.
Replace the vacuum arm into the arm base.
3. Start the machine on by using the front panel button marked 'POWER'.
4. Take the bottle with the cleaning fluid (in the accessory bag) and cut off the marked
top of the dispenser. Gently hold the Clearaudio
No. AC015) against the LP surface and dispense a small amount of fluid the fluid
onto the Record.
Pic.7: Manual fluid application
Please note:
The fluid should just cover the whole record playing surface evenly. Too much fluid will spill
Smart Matrix Professional
onto the
5. Gently hold the cleaning brush against the record while the platter makes
approximately two complete turns in each direction (clockwise and anti-clockwise),
using the button marked 'PLATTER' to change the direction of rotation.
Please note:
If too much fluid is applied, immediately mop up excess fluid with a towel or
similar material to prevent any damage to the record label or to the machine!
Page / Seite 7
Smart Matrix
machine to the mains supply and switch the
or onto the record label.
Professional
User manual / Bedienungsanleitung
Pure Groove
cleaning brush (Art.
 clearaudio electronic GmbH 2013
l