Backlight; Menu Button Use; High Alarm; Low Alarm - RIDGID micro IR-100 Bedienungsanleitung

micro IR-100 Non-Contact Infrared Thermometer
ing the micro IR-100 to ensure good readings. To enable or disable,
while squeezing the trigger, press and release the laser enable but-
ton. The Laser Enable icon will be ON when the laser is enabled.
If using in a low lit area, the micro IR-100 is equipped with a display

Backlight

backlight. To turn the backlight ON and OFF, with the unit ON, press
the backlight button.
After squeezing the trigger, pressing and releasing the menu but-

Menu Button Use

ton will allow you to cycle through the following settings in this order:
High Alarm ON/OFF, High Alarm Temperature Setting, Low Alarm
ON/OFF, Low Alarm Temperature Setting, Temperature Display
Units.
High Alarm will give an audible tone when the current temperature

High Alarm

exceeds a preset limit. To turn the High Alarm ON, squeeze and re-
lease the trigger, and then press and release the menu button until
the High Alarm icon is flashing. Use the up/down buttons to turn
the High Alarm feature ON/OFF as indicated on the current temper-
ature value line. Press and release the menu button again. The
High Alarm icon will continue to flash, and the High Alarm temper-
ature will appear. Use the up/down buttons to change the High
Alarm temperature as desired. Squeeze the trigger to exit the Set-
tings mode and save your selection.
Low Alarm will give an audible tone when the current temperature

Low Alarm

falls below a preset limit. To turn the Low Alarm ON, squeeze and
release the trigger, and then press and release the menu button
until the Low Alarm icon is flashing. Use the up/down buttons to
12
turn the Low Alarm feature ON/OFF as indicated on the current
temperature value line. Press and release the menu button again.
The Low Alarm icon will continue to flash, and the Low Alarm tem-
perature will appear. Use the up/down buttons to change the Low
Alarm temperature as desired. Squeeze the trigger to exit the Set-
tings mode and save your selection.
The micro IR-100 can display temperatures in either degrees Cel-
Temperature Display Units - °C/°F
sius (C) or Fahrenheit (F). To change the display unit, squeeze and
release the trigger, and then press and release the menu button until
the temperature unit on the screen is flashing. Use the up/down but-
tons to switch between F or C as desired. Squeeze the trigger to
exit the Settings mode and save your selection.

Cleaning

Do not immerse the RIDGID micro IR-100 Non-Contact Infrared
Thermometer in water. Wipe off dirt with a damp soft cloth. Do not
use aggressive cleaning agents or solutions. Treat the instrument
as you would a telescope or camera.

Storage

The RIDGID micro IR-100 Infrared Thermometer must be stored in
a dry secure area between -10°C (14°F) and 60°C (140°F).
Store the tool in a locked area out of the reach of children and peo-
ple unfamiliar with the micro IR-100.
Remove the battery before any long period of storage or shipping
to avoid battery leakage.
Ridge Tool Company