Cisco Systems Catalyst 2960 Erste Schritte Seite 14

Troubleshooting Express Setup
Troubleshooting Express Setup
Did you verify that POST successfully ran
•
before starting Express Setup?
Did you press the Mode button while the
•
switch was still running POST?
Did you try to continue without confirming
•
that the switch was in Express Setup mode?
Does your PC have a static IP address?
•
Did you connect a crossover cable instead of a
•
straight-through Ethernet cable between a
switch port and the Ethernet port of the PC?
Did you connect the Ethernet cable to the
•
console port instead of to a 10/100 or
10/100/1000 Ethernet port on the switch?
Did you wait 30 seconds after connecting the
•
switch and the PC before entering the IP
address in your browser?
Did you enter the wrong address in the
•
browser, or is there an error message?
Catalyst 2960 Switch Getting Started Guide
1-8
If Express Setup does not run, or if the Express Setup page does not appear in your
browser:
If not, make sure that only the SYST and STAT
LEDs are green before pressing the Mode button
to enter the Express Setup mode.
If yes, wait until POST completes. Power cycle
the switch. Wait until POST completes. Confirm
that the SYST and STAT LEDs are green. Press
the Mode button to enter Express Setup mode.
Verify that all LEDs above the Mode button are
green. (The RPS LED is off.) If necessary, press
the Mode button to enter Express Setup mode.
If yes, before connecting to the switch, change
your PC settings to temporarily use DHCP.
If yes, connect a straight-through cable to an
Ethernet port on the switch and the PC. Wait 30
seconds before entering 10.0.0.1 in the browser.
If yes, disconnect from the console port. Connect
to an Ethernet port on the switch and the PC. Wait
30 seconds before entering 10.0.0.1 in the
browser.
If not, wait 30 seconds, re-enter 10.0.0.1 in the
browser, and press Enter.
If yes, re-enter 10.0.0.1 in the browser, and press
Enter.
Chapter 1 Getting Started Guide
78-16879-02