Cisco Systems Catalyst 2960 Erste Schritte Seite 10

Running Express Setup
The Express Setup page appears. If it does not appear, see the
Step 11
section on page 1-8
Enter this information in the Network Settings fields:
Step 12
In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID
•
only if you want to change the management interface through which you manage the switch
and to which you assign IP information. The VLAN ID range is 1 to 1001.
In the IP Address field, enter the IP address of the switch. In the IP Subnet Mask field,
•
click the drop-down arrow, and select an IP Subnet Mask.
In the Default Gateway field, enter the IP address for the default gateway (router).
•
Enter your password in the Switch Password field. The password can be from 1 to 25
•
alphanumeric characters, can start with a number, is case sensitive, allows embedded
spaces, but does not allow spaces at the beginning or end. In the Confirm Switch
Password field, enter your password again.
Catalyst 2960 Switch Getting Started Guide
1-4
for help. Note: all entries must be in English letters and numbers.
Chapter 1 Getting Started Guide
"Troubleshooting Express Setup"
78-16879-02