Cisco Systems Catalyst 2960 Erste Schritte Seite 13

Chapter 1 Getting Started Guide
Cisco Network Assistant
Command-Line Interface
Other Management Options
78-16879-02
Cisco Network Assistant is a free software program that you download from
Cisco.com and run on your PC. Network Assistant offers advanced options for
configuring and monitoring multiple devices, including switches, switch clusters,
switch stacks, routers, and access points.
You can enter Cisco IOS commands and parameters through the CLI. Access the
CLI either by connecting your PC directly to the switch console port or through a
Telnet session from a remote PC or workstation.
Follow these steps:
Connect the supplied RJ-45-to DB-9 adapter cable to the 9-pin serial port on
1.
the PC. Connect the other end of the cable to the console port on the switch.
Start a terminal-emulation program on the PC.
2.
Configure the PC terminal emulation software for 9600 baud, 8 data bits, no
3.
parity, 1 stop bit, and no flow control.
Use the CLI to enter commands to configure the switch. See the software
4.
configuration guide and the command reference for more information.
You can use SNMP management applications such as CiscoWorks Small Network
Management Solution (SNMS) and HP OpenView to configure and manage the
switch. You also can manage it from an SNMP-compatible workstation that is
running platforms such as HP OpenView or SunNet Manager.
The Cisco IE2100 Series Configuration Registrar is a network management
device that works with embedded CNS agents in the switch software. You can use
IE2100 to automate initial configurations and configuration updates on the
switch.
Catalyst 2960 Switch Getting Started Guide
Managing the Switch
1-7