Managing The Switch - Cisco Systems Catalyst 2960 Erste Schritte

Managing the Switch

Refreshing the PC IP Address
Managing the Switch
Using the Device Manager
Catalyst 2960 Switch Getting Started Guide
1-6
After you complete Express Setup, you should refresh the PC IP address.
For a dynamically assigned IP address, disconnect the PC from the switch, and
reconnect it to the network. The network DHCP server will assign a new IP
address to the PC.
For a statically assigned IP address, change it to the previously configured IP
address.
After completing Express Setup and installing the switch in your network, use the
device manager, Cisco Network Assistant, or another of the management options
described in this section for further configuration.
The simplest way to manage the switch is by using the device manager that is in
the switch memory. This is an easy-to-use web interface that offers quick
configuration and monitoring. You can access the device manager from anywhere
in your network through a web browser.
Follow these steps:
Launch a web browser on your PC or workstation.
1.
Enter the switch IP address in the web browser, and press Enter. The device
2.
manager page appears.
Use the device manager to perform basic switch configuration and
3.
monitoring. Refer to the device manager online help for more information.
For a more advanced configuration, download and run the Cisco Network
4.
Assistant described in the next section.
Chapter 1 Getting Started Guide
78-16879-02