Programming; Initialization With The Easy Base Unit - Gewiss GW 20 476 Kurzbeschreibung

Initialization with the Easy base unit

1. Power up the device using the bus.
2. Have the system acquire the device with one of the following procedures:
• Automatic learning (the device still has factory default settings):
- in the Easy base unit menu select "Application → New function" or "Application →
Edit function" : the device will be recognized automatically.
• Manual acquisition (the factory settings have been modified):
- select the "Application → Search device" menu in the Easy base unit;
- briefly press (< 2 seconds) the programming button. The programming LED will light
up during the acquisition process (figure A).
The device learned by the Easy base unit will be listed, with the assigned number, in the
menu "Application → New function" or "Application → Edit function".
Physical address programming (S-mode)
Turn on device power via the bus and press the programming button to prepare the
interface to load the physical address from the ETS.

PROGRAMMING

23
E
N
G
L
I
S
H