Gewiss GW 20 476 Kurzbeschreibung Seite 19

When configured with ETS, the burglar alarm system bus interface GW 20 476 provides
the following functions:
Commands
• total system arming/disarming
• Partial system arming 1 (day mode)
• Partial system arming 2 (night mode)
• Trigger transmission alarm status
• Trigger transmission enable arming status
• Scene save/run 2 (max 8)
Signals
• Total system armed status
• Partial system arming 1 status (day mode)
• Partial system arming 2 status (night mode)
• Alarm status
• Arming enabled
• Alarm memory
• Power mains malfunction
• Battery malfunction
• System tamper on
• Sensor status (1..48) / Sensor alarm memory (1.. 48)
Objects) 1 byte
• Sensor status (1..24) / Sensor alarm memory (1.. 24)
Objects) 1 bit
Status/sensor trigger signals are also available when the system is disarmed.
1) the disarm command from the bus can be turned off using an ETS parameter
2) the disarm command can be included/bypassed in a scene using an ETS parameter
3) sensor status functions and sensor alarm memory can be selected using an ETS parameter
GENERAL DESCRIPTION
System functions (S-mode)
1
19
3 , via 6 CO (Communication
3 , via 24 CO (Communication
E
N
G
L
I
S
H