Troubleshooting - mamibot Sweepur 120 Gebrauchsanleitung

Troubleshooting

Common Failures
All lights of IONS and buttons
blink, Robot beeps.
Common Erros in Using of Wet Cleaning Pad (Deep Cleaning Pad)
Common Failures
Water leakage
No liquid exudes from the
cotton core
Common Erros in Using of GyroNavi Box Navigator
Common Failures
Connection failure between
the robot and GyroNavi Box.
Blinking red light on GyroNa-
vi Box Indicator.
The GyroNavi Box indicator
light turns off while cleaning.
With multiple GyroNavi Bo-
xes in use, but only one box
has connection with the ro-
bot.
With multiple GyroNavi Bo-
xes in use, but Sweepur 120
clean areas repeatedly.
Possible Causes
Wrong adapter is used.
Possible Causes
Water container fill cap is
not closed tightly.
Water container outlet
failer or cotton core is
broken.
Possible Causes
Wrong location between
the robot and GyroNavi
Box.
Built-in battery of Gyro-
Navi Box is in low power
or battery is dead.
The robot leaves the navi-
gator's range.
Signal interference from
other devices.
Wrong distance between
Sweepur 120 and other
GyroNavi Boxes.
The signal channel of
GyroNavi Box and the
robot fails compling with
each other.
11
Solutions
Change the wrong adapter and use original ad-
apter for Sweepur 120.
Solutions
Double check the water container outlet cap to
make it closed and placed tightly.
Check the water container outlet, replace bro-
ken cotton core with new.
Solutions
• Press the power switch of GyroNavi Box, place
it at higher position with blue signal light facing
open area.
• Press power switch of robot, place it on floor
2-2.5m from GyroNavi Box, the robot shall face
the GyroNavi Box.
• Attach white quick cleaning cloth, press quick
cleaning button, the robot moves toward the
GyroNavi Box while the Indicator of Navigation
System starts blinking blue light, the robot will
establish connection with GyroNavi Box in 30s.
• When indicator light turns from blinking blue to
solid blue, the connection is established suc-
cesfully.
• If it fails to move forward, please refer to „Com-
mon errors in general use".
Charge the battery through USB cable, or repla-
ce the GyroNavi Box if battery is dead.
The GyroNavi box will turn off its light if the robot
runs out of its range. When the robot returns, the
light will be reactivitated.
Keep the GyroNavi Box away from PDP or LCD TV,
don't place in room with burning fluorescent lamp.
Adjust distance of GyroNavi Box and Sweepur
120 within 4.5m. Make sure the second Box is not
isolated in an area where Sweepur 120 cannot
get to it. Try placing Boxes with just 4.5m between
them to help the robot connect, then move the
boxes farther apart for subsequent cleaning cy-
cles. Do not move the boxes while it is cleaning.
Please check signal track on the bottom of each
GyroNavi Box to confirm whether the signal track
of each GyroNavi Box Navigator is different.