Charging The Battery - Bayan Audio soundbook Bedienungsanleitung

Charging the Battery

• Connect the USB power cable to the Soundbook
• Plug the USB power cable into the supplied AC mains power adapter, and plug this into a mains outlet.
• The first time you use your Soundbook, let it charge for 12 hours to ensure the built-in Lithium battery is properly conditioned.
When the Soundbook detects a low battery state it will display the word LO on the front display.
Listening to Bluetooth Music
• Turn on the Soundbook (open the cover and if necessary press and hold the Power/input button until the Soundbook turns on
– it will remember the last selected input and go to this automatically.
• If necessary, change the input to BLU (Bluetooth) – short-press the centre Power/input button to cycle through the inputs until
the display shows BLU
Connect by NFC – Automatic paring
If your audio source supports NFC, you can use NFC Secure Simple Pairing to connect your phone to the Soundbook
• Turn on your audio source and unlock the screen
• Ensure that NFC is enabled in the settings on your audio source
• Touch the back of your audio source to the back cover of the Soundbook where the NFC logo is located
– you will be asked to confirm that you wish to connect and pair with the Bayan Soundbook – select Yes/OK.
• You can disconnect by simply touching your audio source again to the back cover of the Soundbook.
English
Connect by traditional Bluetooth Pairing
If your audio source does not support NFC but is Bluetooth enabled, you can use Bluetooth Secure Simple
Pairing to connect and stream music:
• Consult your audio source user manual for instructions on how to pair with Bluetooth devices – generally you will need to go
into your settings > Bluetooth > scan for new Bluetooth devices and select 'Bayan Soundbook'. You will not be prompted for
a passcode for pairing.
Note:
• For secure simple pairing to work, your MP3/phone/tablet/laptop must be in close proximity to the Soundbook when trying
to pair (within a range of 1 metre)
• After pairing is successful, paired devices will remember each other – unless pairing information is deleted there is no need
to carry out pairing again. Soundbook can remember the last 4 audio sources that it was paired with.
• Soundbook will automatically connect to the last audio source it was connected to (if it is in range). If you want to connect
:
1 to an alternate audio source, switch off Bluetooth on the current connected audio source, and then pair/connect with the alternate
audio source according to the steps outlined above.
NOTE: To achieve the best audio quality, ensure your MP3 recordings are sampled at a high bit rate (ideally 320kbps Stereo),
and your source device supports aptX
®
Bluetooth Hands Free Calling
The Soundbook has an integrated microphone to enable you to make hands-free calls or use the Soundbook for conference
calling as a speakerphone.
To make a call via Bluetooth, initiate the call from your mobile phone, and then on the phone, select the Soundbook as the audio
device for the call.
To answer a call via Bluetooth, accept the call from your mobile phone, and on the phone select the Soundbook as the audio
device for the call.
digital audio compression.
English