Charging The Battery; Bluetooth Status - Bayan Audio soundbook GO Kurzanleitung

Charging the Battery

• Connect the USB power cable to the Soundbook Go
• Plug the USB power adapter into your phone charger's USB socket, or into your computer.
• Your Soundbook Go has been shipped to you already charged so that you can enjoy it straight away, however, when you charge
it for the first time, please let it charge for 12 hours.
• Charging is complete when the illuminated USB charge port turns green
Listening to Bluetooth Music
• Turn on your Soundbook Go (open the cover and if necessary press and hold the Power button until your Soundbook Go turns on).
• Check if the Bluetooth LED is illuminated – if not, short-press the Power Button to select the Bluetooth Input.
Connect by NFC – Automatic pairing
If your audio source supports NFC, you can use NFC Secure Simple Pairing to connect your phone to the Soundbook Go
• Turn on your audio source and unlock the screen
• Ensure that NFC is enabled in the settings on your audio source
• Touch the back of your audio source to the back cover of your Soundbook Go where the NFC logo is located
– you will be asked to confirm that you wish to connect and pair with the Bayan Soundbook – select Yes/OK.
• You can disconnect by simply touching your audio source again to the back cover of your Soundbook Go.
English
Connect by traditional Bluetooth Pairing
If your audio source does not support NFC but is Bluetooth enabled, you can use Bluetooth Secure Simple
Pairing to connect and stream music:
• Consult your audio source user manual for instructions on how to pair with Bluetooth devices – generally you will need to go into
your settings, Bluetooth, scan for new Bluetooth devices and select 'Bayan SBK GO' You will not be prompted for a pass-code for
pairing.
Note:
• For secure simple pairing to work, your MP3 /phone / tablet / laptop must be in close proximity to your Soundbook Go when
trying to pair (nominally within a range of 50cm)
• After pairing is successful, paired devices will remember each other – unless pairing information is deleted there is no need to carry
out pairing again. Soundbook Go can remember the last 4 audio sources that it was paired with
• Soundbook Go will automatically connect to the last audio source it was connected to (if it is in range). If you want to connect to
1 :
an alternate audio source, switch off Bluetooth on the current connected audio source, and then pair / connect with the alternate
audio source according to the steps outlined above.

Bluetooth Status

The Soundbook Go display will show the current status of the Bluetooth connection. The Bluetooth status light
diagram) will flash when there is no Bluetooth audio source connected to the Bluetooth speaker, and will illuminate solid when a
Bluetooth audio source is connected.
Note:
If you are trying to connect your audio source to your Soundbook Go via Bluetooth and another device is already connected (e.g.
the Bluetooth status light is illuminated solid), Soundbook Go will reject your connection request – you must first disconnect the
Bluetooth source that is already connected to your Soundbook.
(shown in the
English