Childproof Lock - Zibro SRE 440 E Gebrauchsanweisung

H: When the mark
appears, the childproof
lock has been activated.
I: When the SAVE
function is activated, the
heater will automatically
switch on or off in
order to remain within
a specified temperature
range.
THE USE OF THE MOTION DETECTION SENSOR
This heater is equipped with a motion detection sensor. The sensor is placed at
the front side of the heater and it signals every single movement. The motion
detection sensor has a horizontal detection angle of 80
angle of 20 . The sensor detects movements as far as 7 m.
o
If the sensor does not detect movements for 10 minutes then the heater will
automatically switch to a lower combustion level. As a result less fuel will be used.
Switch on the motion detection sensor;
Switching on the motion detection sensor can only be done when the heater is
turned on. Push the "Motion" button
light will light up (green).
If the sensor does not detect movements for 10 minutes then the heater will
automatically switch to a lower combustion level. The motion detection sensor
light keeps lighted up. If the sensor detects movement the motion light will blink.
The heater switches back to the latest temperature setting.
Switch off the motion detection sensor;
The Motion detection sensor can be switched off by pressing the "Motion" button
again. A sound signal will be heard and the "Motion" light will go out.
Remote control
This heater is equipped with a remote control. The functions on the remote
control are the same as the functions on the display of the heater.
I

CHILDPROOF LOCK

The childproof lock can be used to prevent children accidentally changing the
heater settings. When the heater is burning and the childproof lock is on, the heater
can only be switched off. Other functions are blocked then. If the heater has already
been switched off, the childproof lock also prevents accidental ignition of the
heater. Activate the childproof lock by pressing the appropriate key
it down for more than 3 seconds. The KEY-LOCK indicator (
information display (Fig. H), indicating that the childproof lock has been activated.
Switch off the childproof lock by pressing the key
than 3 seconds once again.
J
THE CORRECT USE OF 'SAVE'
The 'SAVE' function allows you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature
exceeds the set temperature by 3°C. Subsequently, when the room temperature has
dropped again to the set temperature, the heater will automatically switch on again.
Activate the 'SAVE' setting by pressing the appropriate
information display (Fig. I). Switch off the function by pressing the SAVE key once again.
Without the 'SAVE' setting your heater will maintain the set temperature by
approximation as well, by adjusting its heating capacity. 'SAVE' is an economy
setting, which you can use when, for instance, you are not present in the room
or to keep it frost-free.
and a vertical detection
o
. A signal will sound and the "Motion"
) will appear on the
and holding it down for more
key. will display on the
and holding
4
81