About The Standby Screen; Setting The System; Unsetting The System - Scantronic i-on Serie Benutzerhandbuch

For a part-setting system,
these set part set B, C or D*.
For a partitioned system, they
fully set partition 2, 3 and 4
respectively*.
Unsets the system.
A Hold Up Alarm (HUA) is
started when both of these
keys are pressed (if enabled
by the installer).
*This is the default action; the installer can
configure these keys perform a different
setting action, or to operate an output.

About the standby screen

When the system is idle (either while set
or unset), the display shows the "standby
screen" . For example:
i-on40H+
10:43 03/07/2019

Setting the system

Readying the system to start an alarm if
someone moves into a protected area is
called "setting" the system.
You can set your system using a variety of
different methods, depending on system
configuration. The following explains a
typical method using a keypad.
Note: Please refer to the Administration
and User Manual for full details.
1. Enter your access code or present your
proximity tag at the keypad. If you
enter your access code, the display
shows a * for each completed digit:
Enter Access Code:
(*
2. If setting options are displayed, you
can press  or  followed by  to
choose the option you require:
Setting Options
Full Set All
Page 8
)
• Full Set/Fulll Set All : To set the whole
system. Alternatively, press the A
key*.
• Part Set B\C\D : To set part set B, C or
D only. Alternatively, press the B, C
or D key*.
• Partitions : To set or part set a
partition. Alternatively, press the B, C
or D key to full set a partition*.
*Your installer may have configured
the system to allow you to quick set
using A, B, C or D without entering an
access code or presenting a proximity
tag first.
3. You will hear a continuous exit tone
(unless the system is configured for
silent or instant setting).
The system sets when one of the
following occurs, depending on how
the system is configured:
• Immediately.
• After a period of time.
• When you exit the premises.
The A, B, C or D key illuminates to
indicate the set status (unless disabled
by the installer). For example, in a part-
setting system, the A key is illuminated
if the system is fully set.

Unsetting the system

Disarming the system so that people can
move freely is called "unsetting" .
To unset the system from a keypad:
1. Enter through the designated entry
route. Do not stray from this route –
you may cause an alarm.
2. If you hear a tone, go directly to the
keypad, since you will have limited
time to unset the system before it
generates an alarm.
3. Enter your access code or present your
proximity tag.